Stock ratio: Front down approx. 15mm, rear equivalent to stock
Seat base, mounting hardware, and damper pre-installed
mesh
Approximate installation time: 0.5h

**It is waterproof, but not completely waterproof.After driving in the rain, water may seep through the sewn parts of the seat leather.
*Pillion seat belt is not included.A Daytona grab bar or assist grip must be installed at the same time.
*Only for stock exterior parts.This product may not be able to be installed in combination with aftermarket exterior parts.
*There may be changes in product specifications due to the manufacturer’s reasons..

The pattern is inspired by the famous Z1000R of yesteryear, and is arranged to match the form of the Z900RS.
This is a lowered seat with the front side section cut and the seat surface lowered by approximately 15mm.
The hardness and elasticity of the integrally molded super urethane allows the entire seat to take the rider’s weight, reducing fatigue even after sitting for a long time.
The seating area is designed to be almost horizontal to the ground, and the moderate amount of seat down improves maneuverability and stability.
Mounting hardware and dampers are pre-installed in the seat base, and can be installed with stock in-vehicle tools.

Complete seat with special PP base
Rider side: approx. -15mm
The pillion side is the same as stock.The form emphasizes the edges.
Mounting bracket and damper already installed
Stock in-vehicle tools can be installed.