[Manufacturer’s Part Number] 280-313H

*
*If the instruction manual is attached, it is in a foreign language because it is an imported product.
*There may be changes in product specifications due to the manufacturer’s reasons..

* The image is only for reference. The image shown may differ from the actual product.

HIGHSIDER AKRON-RS license plate holder

The HIGHSIDER AKRON-RS license plate holder adapts perfectly to the lines of your motorcycle thanks to its design.

The model-specific bracket of the AKRON-RS allows mounting on the original mounting points of your motorcycle and thus a replacement without further drilling or cutting.
To prevent damage to cables, all sharp-edged feedthroughs are protected by a rubber membrane grommet.

The license plate is made of sheet steel and 2mm thick. The precise cutting is done by laser. After edging, the weather-resistant black powder coating is applied.
This ensures the optimal fit and durability.
Through the full adjustable you can bring the plate without drilling in the desired position. To keep the plate in this position, there is an additional locking screw.

The AKRON-RS turn signal brackets are adjustable in width and therefore suitable for any type of accessory turn signal. This adjustment option allows you to adapt the position for your turn signals to the most varied license plates. To allow mounting the turn signals without disconnecting them from the wiring harness, the 10mm holes are slotted to the side.

You can also adjust the position of the reflector individually via a slider. An adaptation to the different designs of the EU license plates is therefore no problem.

To screw the license plate securely and reduce vibration, two rubber washers are included. Another rubber buffer supports the license plate on its underside.

Details:
– model-specific bracket
– infinitely adjustable turn signal holder
– slotted turn signal holder for easy mounting without cable separation
– infinitely adjustable reflector, E-approved
– suitable for European license plates
– infinitely adjustable tilt angle
– additional screw for optimum position security
– easy fixation without further work steps (eg. Drilling)
– easy mounting of the license plate through slotted holes

Included in the scope of delivery of the AKRON-RS are:
– Model-related bracket with mounting parts
– AKRON-RS license plate retainer
– Adjustable turn signal brackets
– E-tested reflector with adjustable bracket
– Mounting instructions

Notes:
– For the original blinkers, a special blinker bracket is optionally available in the accessories tab.
– If your original license plate holder has reflectors fitted to the side,these must be refitted in a suitable position or replaced with new ones

Tips:
If you have not found a model-specific license plate holder for your motorcycle, the universal license plate holders from HIGHSIDER, which are available in many different designs, are certainly a good alternative.